Open
the drain at the bottom of the water basin and wash dust and dirt
away while scrubbing the water basin with a brush.
2.2
Trial Circulation Wafer
Fill
water in the water basin to the level where the discharge from the
ball tap stops.Slowly
rotate the sprinkler by hand to check whether it is free.Start the circulating pump, and after washing the interior of
the tower and the water pipes thoroughly, refill the circulating
water.
2.3
Checking
After
the circulation test, check if there is any dirt or foreign matter
sticking to the interior of the tower or the outlets of the
sprinkling pipes.Check
to see if the speed reducer belt has been adjusted correctly.
After
confirming that that the fan revolves smoothly by turning it by
hand, check the state of the gap between the tip of the blades and
the tower casing.Measure
the supplied voltage and make sure that the power supply is in the
regulated type.Revolve
the fan for a short time and make sure that air is blown upward.Revolve the fan two or three hours to see if any vibrations
or abnormal sounds are generated.
