In order to make the circulating water fill every part of the
circulation system, revolve the circulation pump for a short while,
to drain the air out of the piping of the circulating water.
Before entering steady operation, confirm again that the
water basin is filled to the specified level, and then start the
pump.
Gradually open the adjusting valve and adjust it so that the
water will reach the volume specified on the name plate of the
cooling tower.When
circulation of water becomes steady, check to see if the sprinkler
is revolving smoothly and properly.
3.2 Fan Driving
Clean up the surroundings of the tower and make sure that no
foreign matter is near the air inlet and outlet.
When the equipment goes into steady operation,
measure phase voltages and phase currents to see if the motor is
operating at the rated current range indicated on the name plate.
